Due to the router or IP address, users often get the error “Ethernet doesn’t have had a valid IP configuration” on Windows. When encountering this situation, you should use some ways to fix “Ethernet doesn’t have a valid IP configuration” on Windows to continue using the network normally.
On computers, especially laptops using WiFi connection, we often encounter Limited WiFi error, limiting the connection to WiFi. When you encounter this error, you will not be able to access the connecting WiFi network, even if you have entered the correct password. Users who want to fix Limited WiFi errors, restrict connections to WiFi cannot be changed need to change the IP address or perform some other actions. Because on certain WiFi, the IP parameters will be set differently, if it is a static WiFi WiFi, you need to enter a static IP to connect to the Internet. As for dynamic IP, you need to switch back to the dynamic IP self-recognition mode only. Another error is also related to the IP that we sometimes encounter “Ethernet doesn’t have a valid IP configuration” error on the Window. This error usually comes from the Router or by assigning the wrong IP address. To fix the error “Ethernet doesn’t have had a valid IP configuration” on Windows, please refer to the following instructions.
How to fix “Ethernet doesn’t have had a valid IP configuration” error on Window:
1. Restart the computer to fix the “Ethernet doesn’t have had a valid IP configuration” error on Windows.
This is the simplest way, so it should be used first if the computer naturally makes an error “Ethernet doesn’t tried to have a valid IP configuration”. Very likely after rebooting will fix this error.
2. Change your Modem or Router.
You can change your Router or Modem to try connecting to see if the computer still says “Ethernet doesn’t have a valid IP configuration” error.
Alternatively, turn off the modem for about 30 seconds to 1 minute, then reboot and try to connect to the Internet.
Alternatively, switch from a WiFi connection to a wired network.
3. Check your network configuration to fix “Ethernet doesn’t have a valid IP configuration” error on Windows.
Step 1: Press Start , search cmd and open Command Prompt with Admin rights.
Step 2: In the interface Command Prompt you enter:
ipconfig / all
Then press Enter.
IP and network address parameters will appear in the Command Prompt.
Step 3: Next click on the Internet icon in the left corner of Destop, select Open Network and Sharing Center.
Step 4: Select the currently connected connection and press Right-click> Properties.
Step 5: Select section Internet Protocol Version (TCP / IPv4), pressing Properties to edit. Check if the IP address is in the form 192.168.xxx.xxx or not.
Step 6: Finally go back to Network Connections and right click Disabled to turn off Internet connection.
And press Enabled to turn it back on
After completing these operations, please check to see if the “Ethernet doesn’t have a valid IP configuration” error has been completely fixed on Windows.
In addition, on the computer, there are countless errors related to network connection that everyone has encountered. Therefore, Taimienphi.vn has created articles summarizing the errors and how to fix computer network errors for users to use. In the article about fixing a lost computer, there are 7 most common errors about the Internet connection, so you should read through to identify these errors. You can also save the article to be able to open, see the help instructions on the phone to fix your laptop, computer.